Elastoplast Spiral Heat Multi-Purpose is a flexible heat patches for targeted pain relief.

Spiral heat is a medical device intended for the relief of muscle and joint pain due to tight and cramped muscles, over-exertion, sprains, strains, and arthrosis.

Spirotherm tech-flex.

Soft touch, extra discreet.

Spiral heat is available in special shapes for neck/Back/shoulder application and multipurpose application.

Directions:

It can take up to 30 minutes until the heat patch warms up to an effective heat level. Thus, the pouch should only be opened directly before use.

The patch should only be applied on clean, dry and unbroken skin. Open the pouch and remove the sealing paper from the back of the patch.

Place adhesive side of spiral heat to the skin directly over the painful area and press on firmly. After use slowly peel off from the skin.

The patch should not be worn for more than 12 hours within any 24 hour period. Only for single use - For each application use a new patch to retain the described heat effect.

Warnings:

To avoid the risk of burns allow air to circulate over the heat patch and avoid extra pressure such as lying or sitting on the heat patch, wearing under tight clothing or a belt and leaning against hard surfaces.

Do not overlap heat cells when applying to joints.

The heat spirals contain Iron powder.

If your skin or eyes come into contact with the content of the cell, rinse with water.

If ingested rinse Mouth.

In all cases, seek medical advice immediately.

Do not cut the product.

Do not try to reheat or put into a microwave.

Remove the product before undergoing a mi (magnetic resonance imaging) procedure.

End usage of product immediately if you feel any skin irritations or burns or if the product feels too hot.